How To Prolong The Service Life of Hospital Hermetic Door

1. The dust on the industrial purification door should be removed in time, and the hospital hermetic door, tempered glass and hardware should be cleaned. Even if it is stainless steel sheet, dust and dirt are absorbed on the control panel for a long time, the chemicals in it will also corrode the surface of the stainless steel sheet, and in the long run, the steel body will be harmed and the operation characteristics of the hospital hermetic door will be damaged.

2. Once the air on the hospital hermetic door is contaminated with oil stains and other difficult-to-remove objects, it cannot be removed with a strong acid or alkali solution. It is not only easy to damage the surface gloss of the frame of the single-open automatic door, but also damage the surface of the hardware. The protective film and oxide layer caused by the corrosion of the hardware, especially when some customers use sulfuric acid to clean the wall, take care not to let the purification treatment window and door become contaminated.

3. Dirt such as particles on the inside of the frame should be eliminated immediately to prevent it from blocking the safety exit of the sewage pipe and causing the sewage pipe to encounter obstruction and leakage. The serious consequences will continue to damage the operation of the radiation protection sensor door again, and reduce the sensor door Lifetime, and there are hidden safety hazards.

4. When opening the automatic door of the wooden hospital ward door, the force should be appropriate, and try to keep the speed even when opening and closing.

5. Usually when entering and exiting the hospital hermetic door, avoid rampaging, and try to avoid hard objects hitting the radiation protection induction door or scratching the surface of the door frame.

6. When it is found that the hospital hermetic door has inflexible opening or other abnormal conditions during use, the reason should be searched immediately. If the consumer cannot check the common failures himself, he should immediately contact the manufacturer or agent of the radiation protection induction door , Which is conducive to the elimination of common problems immediately. If the induction door is not repaired immediately, it should be suspended to prevent accidents.